Heavy Duty Ceramic Mugs for Restaurants and Catering
In a restaurant a mug is not a cup, it is equipment. It goes through a dish machine 8 to 12 times a day, gets stacked wet, and is knocked against a steel rack every cycle. Heavy duty mugs are specified for that life, not for shelf appeal.
生产范围与限制
| 容量 | 8–20 盎司；11 盎司和 12 盎司是标准的商用规格 |
| 墙 | 5–7 mm body, rolled rim |
| 正文 | 石质陶器，烧成温度1180–1220°C，吸水率低于3% |
| 手柄 | 拉力测试要求最低8千克，每件产品进行三次拉力测试 |
| 最小起订量 | 500 pcs per colour and capacity |
| 纸箱 | 36 或 48 件，0.03–0.04 立方米 |
| 交货期 | 样品确认后25–30天 |
Where commercial mugs fail first
Not in the body. The first failure is the handle joint, because a wet mug is gripped by the handle alone and the joint sees repeated load at 60–70°C. The second is rim chipping from rack contact, and the third is glaze crazing after roughly 300 wash cycles if the body was fired below 1150°C. We fire above 1180°C for this reason, and the rolled rim spreads impact instead of concentrating it on an edge.
What we can adjust for your operation
Wall thickness from 5 to 7 mm, foot ring height, handle opening from 25 to 32 mm, and base diameter to fit an existing rack. If your dish machine uses a specific rack pitch, send the pitch and we will confirm the stack height before sampling.
包装
36 or 48 per 5-layer carton with paper interleaves, drop tested at 1.2 m on all six faces. Damage allowance is 2%; anything above that is replaced on the next order.
订购
500 pcs minimum per colour, mixed colours load in one container. For hospitality groups we hold the approved sample for 24 months so replacements match the original delivery.
Other formats in 陶瓷杯.
Can the mug be branded?
Yes — decal, underglaze print or laser. Decal is the only finish rated for 500 wash cycles.